Help with ADSR multiplexing (solved)

[jackmillarnz]

Hi there! i am pretty new to this compared to most of you im assuming so please don't judge my lack of knowledge

I am trying to figure out how to create an ADSR module that i can route to different OSC pitches as i choice in the GUI.

I have created an ADSR and connected it to a multiplexer, but my question is where to send the outputs, i tried setting a stream multiply in between my detuner and the oscillator, but then when i disable the ADSR or send it to a different place, the output from that oscillator mutes.

Any help would be greatly appreciated!

Thanks.

Jack.

[Drnkhobo]

Thats because you are multiplying a stream by 0....which makes it 0. You need to have another multiplex to add either 0 or 1 to that input again depending on the multiplex state.....

take a look:

Schematic1.fsm

(27.48 KiB) Downloaded 740 times

[jackmillarnz]

thank you! that makes sense

i have it working as it should now.

[Drnkhobo]

[Sumeraxe6]

I made this in ruby, which greatly facilitates the entire management.
For any questions please do not hesitate to ask.