Triggering switches with Midi notes.

[lalalandsynth]

OH, really, thats it , and this works as polyphonic?

[lalalandsynth]

Yep, this works, except it went back to a mono signal, checking if i did something wrong.
I changed the one you made to work with 12 stereo channels or 24 mono ,so each note was triggering a stereo channel.
With the ADSR that is lost and I am back to mono.

I can upload my schematic if you can open an alpha ?

Donated

[lalalandsynth]

With this configuration through the adsr I get mono.
Ones below are from before with no ADSR and they work as stereo.
Must say , I am a bit frustrated that my skill level is so low that I cannot figure this out .
I could obviously just have 2 Adsr´s with one set of controls but that seems like a workaround

Mono.jpg (155.96 KiB) Viewed 13122 times

[lalalandsynth]

Stereo configuration

config.jpg (191.23 KiB) Viewed 13122 times

[martinvicanek]

You can go stereo like this:

StereoRoting.png (16.82 KiB) Viewed 13119 times

Simply pack and unpack the L/R channels into a Mono4 stream - everything else remains unchanged.

There is a lot to optimize but that's for later. Thanks for the donation!

[lalalandsynth]

Thanks again , so simple ...unless you dont know how

[lalalandsynth]

Hmm, everything sound distorted now.
Having a look, sounds fine in FS (EDIT: IT IS DISTORTED IN FS AS WELL: ,distorted in Reaper, previous version without ADSR sounded fine in Reaper

Not sure what happened , it sounded fine in mono.
No reason for it to be the Pack/unpack , already using that in the volume knob and Clip.

Its weird I can pull the gain from my test osc to -70 , still has no effect on lowering the sound.
Same thing in reaper , lowering the input file had almost no effect , almost like everything is normalized/maximized and distorted ?

Ok, so bypassing the adsr and going straight from pack to unpack solves the distortion , distortion happens at the adsr ,

[lalalandsynth]

Replaced all ADSRs with the same one from the toolbox and it now works !?
Who knows , might be an alpha issue ?

[lalalandsynth]

Lol, still some issues , Looks like if the release gets stuck at almost full levels.
I just move the knob slightly from zero and it plays full release, and not always .
Something is still wrong.

EDIT: The envelope gets stuck on "Full release" in FS and reaper ,when the decay is on full and the release is lifted slightly.

Taking a break

[lalalandsynth]

Sent you a PM Martin.